The stock size of the high strength of the clamp nut
Our standing in the clip can be used for sheet metal, plastic sheets and other sheet. These clips have a positive ring, this ring is in the assembly and disassembly can clip secure.
Clip
The spring clip can automatically To ensure proper installation, the minimum diameter of the plate hole (H) must comply with the values in the table。
Nut
All nuts are nuts, in accordance with MIL-N-25027. No. S10725-281 of the nut does not require lubricants, and all other nuts are dry film lubricant for lubrication. The thread size, such as shown in the parts table. Can not exceed a maximum torque value.  
Thickness of the plate
The plate thickness of each part has a range of valuesPart Number S08125-250 of the clip, the plate thickness range is
0.020 in. (0.51 mm) to 0.125 in. (3.18 mm)。
Location of holes
The center of the hole size is the maximum possible distance of the center of the hole and the edge of the board. The hole can be located near the edge, but this is the case, clip protruding。
Material
Are high carbon steel nuts and clips made ??of and after heat treatment to achieve optimal performance。
Last channel Qiceng,
Clip and the surface of the nut, cadmium plated, or galvanized and chromate processing。
Maximum torque
Thread Size |
The field of torque
* |
- Lb |
Newton - mm |
4-40 |
17 |
1921 |
6-32 |
26 |
2938 |
8-32 |
34 |
3842 |
10-32 |
51 |
5763 |
1/4-20 |
85 |
9605 |
| * Out the torque generated by the nut on the clamp。 |
|
